Introduction
Part three of four posts in response to Michael Bara’s five-part post that allegedly destroys my arguments that the ziggurat on the moon is not real. Next post is already written (mostly) and will come out shortly, wrapping things up.
Dynamic Range
I really think I’ve covered this enough by this point, but I’ll do it briefly again.
Below is the “original” ziggurat image that Mike has linked to. Below that is a histogram of its pixel values. Note that this looks slightly different from what Photoshop will show the histogram to be. That’s because Photoshop fakes it a teensy bit. This histogram was created using very rigorous data analysis software (Igor Pro) and shows a few spikes and a few gaps in the greyscale coverage:
Original Lunar Ziggurat Image from Call of Duty Zombies Forum
Histogram of Pixel Values in Original Ziggurat Image
The dynamic range available for this image is 8-bit, or 0 through 2^8-1, or 256 shades of grey (or 254 plus black plus white — semantics). The actual dynamic range the image covers is less than this — its range is only 12 through 169, or 157 shades of grey — just a little over 7-bit.
Compare that with the NASA image (whether you think the NASA image has been tampered with or not, that’s unimportant for this explanation), shown below. Its histogram spans values from 0 through 255, showing that it takes up the entire 8-bit range.
“Ziggurat” Area in NASA Photo AS11-38-5564
Histogram of Pixel Values in Original NASA Image of Ziggurat Location
The immediate implication is that the ziggurat version has LOST roughly half of its information, its dynamic range. Or, if you’re of the conspiracy mindset, then the NASA version has been stretched to give it 2x the range.
Another thing we can look at is those spikes in the dark end and the gaps in the bright ends. I was honestly surprised that these were present in the NASA one because what this shows is that the curves (or levels) have been adjusted (and I say that with full realization of its ability to be quote-mined). The way you get the spikes are when you compress a wide range of shades into a narrower range. Because pixels must have an integer (whole number) value, rounding effects mean that you’ll get some shades with more than others.
Similarly, the bright end has been expanded. This means the opposite – you had a narrow range of shades and those were re-mapped to a wider range. Again, due to rounding, you can get some values with no pixels in it.
This can be done manually in software, or it can also be done automatically. Given the spacing of them, it looks like a relatively basic adjustment has been made rather than any more complicated mapping, for both the Call of Duty Zombies image with the ziggurat and NASA’s.
The fact that BOTH the ziggurat one and the NASA one have these gaps and spikes is evidence that both have been adjusted brightness-wise in software. But, taken with the noise in the ziggurat one, the smaller dynamic range, and the reduced detail, these all combine to make the case for the ziggurat version being a later generation image that’s been modified more than the NASA one (see previous post on noise and detail — this section was originally written for that post but I decided to move it to this one).
Dark Pixels, Shadow, and Light
What is also readily apparent in the NASA version is that there are many more black pixels in the region of interest. This could mean several very non-conspiracy things (as opposed to the “only” answer being that NASA took a black paintbrush to it).
One is what I have stated before and I think is a likely contributor: The image was put through an automatic processing code either during or after scanning, before being placed online. As a default in most scanning software, a histogram of the pixel values is created and anything darker than 0.1% is made to be shade 0, and anything brighter than 0.1% of the pixels is made to be shade 255. Sometimes, for some reason, this default is set to 1% instead, though it is also manually variable (usually).
Another part of this that I think is most likely is that, as I’ve said before, shadows on the moon are very dark. A rough back-of-the-envelope calculation is that earthshine, the only “direct” light into some sun-shadowed regions on the near side, is around 1000x fainter than sunlight would be. On the far side – and these photos are from the far side – there is no earthshine to contribute.
Which means the only other way to get light into the shadowed region would be scattering from the lunar surface itself. Mike misreads several things and calls me out where I admitted to making a mistake in my first video (Mike, how many mistakes have you made in this discussion? I’ve called you out on two very obvious ones in previous posts, and I call you out on another, below). Yes, you can get scattered light onto objects that are in shadow. If you have a small object casting a small shadow (such as a lunar module), then you have a very large surface surrounding it that will scatter relatively a lot of light into it. That’s why the Apollo astronauts are lit even when they are in the shadow of an object.
However, if you have a very large object – such as a 3-km-high crater rim – that casts a shadow – such as into the crater – then there is much less surrounding surface available to scatter light into the shadowed region. Also, remember that the moon reflects (on average) only about 10% of the light it receives*. So already any lunar surface that’s lit only by scattered light would be 10x fainter than the sun-lit part, and that’s assuming that ALL light scattered off the sun-lit lunar surface scatters into the shadowed parts to be reflected back into the camera lens, as opposed to the vast majority of it that just gets scattered into space.
*As opposed to Mike’s claim: “Since the lunar surface is made mostly of glass, titanium and aluminum, it tends to be very highly reflective.” Um, no (source 1, source 2).
Now, yes, there will still be some light scattered into the shadowed region, but it will be very little, relatively speaking, compared with the shadow of a small object, and it will be even less, relatively speaking, when compared with the sun-lit surrounding surface. For example, let’s look at AS11-38-5606:
Apollo Image AS11-38-5606
This image was taken at a low sun angle, and there are a lot of shadows being cast. And look! They’re all very very black. The photographic exposure would need to be much longer in order to capture any of the minuscule amount of light scattered into the shadowed regions that were then scattered into the camera.
Now, before we go back to the ziggurat, let’s look at another part of this claim. Mike states: “I have seen hundreds, if not thousands, of lunar images where the shadows are far from “pitch-black (or almost pitch-black).””
In support of this, Mike points to images such as AS11-44-6609:
NASA Apollo Photo AS11-44-6609
If you go to the full resolution version, you do see that the shadowed regions are not pitch black! WTF is going on!?
First, if you check the levels in photoshop, the 0.1% clip has either already been applied or it was never relevant to this image. So this does not falsify my previous statement of that being a possibility for the black shadows in the “ziggurat” one.
Second, let’s look at a few photos later, AS11-44-6612:
NASA Apollo Photo AS11-44-6612
See that big crater up to the top? That’s the same one that’s near the middle-right in #-6609. Notice that instead of having a greyscale equivalent of around 25%, this time that very same shadow, taken just a few seconds or minutes later but at a different angle and part of the lens has decreased in brightness by over half. Meanwhile, shadows that are in roughly the same position of the frame (as in middle-right versus upper-middle) have a similar brightness as that shadow did in #-6609.
Also, look at the black space above the lunar surface (the right of the frame unless you’ve rotated it). The part of the sky near the top and bottom is ~5% black. The part near the middle is around 13% black. Or, 2-3x as bright, when space should be completely dark in this kind of exposure under ideal optics.
If you’re a photographer, you probably know where I’m going with this: The simplest explanation is that this is either a lens flare from shooting in the general direction of the sun, and/or this is grime on the lens causing some scattering. Less probable but still possible would be a light leak.
And, a closer examination of the shadowed areas does show some very, very faint detail that you can bring out, but only towards the middle of the image where that overall glow is.
Meanwhile, if you look through, say, the Apollo 11 image catalog and look at the B&W images, the shadows in pretty much every orbital photo are completely black. The shadows in the color ones are not.
As a photographer, this is the most likely explanation to me to explain AS11-44-6609 and images like it where Mike points to shadows that are lit:
- Original Photography:
- Image was taken in the general direction of the sun so that glare was present.
- And/Or, there was dirt on the lens or on the window through which the astronauts were shooting.
- This caused a more brightly lit part of the image to be in a given location, supported by other images on the roll that show the same brightness in the same location of the frame rather than the same geographic location on the moon.
- Some scattered light from the lunar surface, into the shadowed regions, off the shadowed regions, into the camera, was recorded.
- Image Scanning:
- Negative or print was scanned.
- Auto software does a 0.1% bright/dark clip, making the darkest parts black and brightest parts white. This image shows that effect in its histogram.
- This causes shadows at the periphery to be black and show no detail.
- Since the center is brighter, there’s no real effect to the brightness, and the very faint details from the scattered light are visible.
Contrast that with AS11-38-5564 (the ziggurat one), which has even illumination throughout. A simple levels clip would eliminate all or almost all detail in the shadowed regions. And/or, the original exposure was somewhat too short to record any scattered light. And/or the film used was not sensitive enough, which is bolstered as a potential explanation by what I noted above – that orbital B&W photography from the mission shows black shadows while orbital color shows a teensy bit of detail in some of the shadows.
In my opinion, that is a much more likely explanation given the appearance of the other photos in the Apollo magazines than what Mike claims, that NASA painted over it.
Which after long last brings us back to the ziggurat. Even in Mike’s exemplar, the stuff in the brightest shadow are BARELY visible, much less-so than the wall of his ziggurat. I suppose if Mike wants to claim that the ziggurat walls are 100% reflective, plus someone has done a bleep-load of enhancement in the area, then sure, he can come up with a way for the walls to be lit even when they are in shadow.
Do I think that’s the most likely explanation, especially taken in light of everything else? No.
Final Thoughts on This Part
One more part left in this series, and by this point I’ve really addressed the main, relevant points in Mike’s five-part series.
Far from “destroying” my arguments, I think at the very, very most, he’s raised some potential doubt for one or two small parts of my argument that, taken individually if one is conspiracy-minded and already believes in ancient artifacts on the moon, then those individual doubts could be used to make it look like the ziggurat is real.
However, taken as a whole, and taken with less of a conspiratorial mindset and a mindset where you must provide extraordinary evidence for your extraordinary claim, and you must show that the null hypothesis is rejected by a preponderance of indisputable evidence, then the ziggurat is not real.
Exposing PseudoAstronomy 